Clover Display M302 hack

Its been a while i have this LCD and today i thought of connecting the LCD display to Arduino. Unfortunately i could not found any pin outs of this from any where and from the manufacture. Actually this is very old model which i got from old FAX machine and this display is a very cheap from online sources.

Clover Display M302 PCB Ver 1.0 (16x2) which has 10 pin flat cable. After researching for a while from the internet i have seen in many forums people are asking for help on how to connect it and what is the pin configurations? so i thought of helping them as well as my self at the same time.

After going through some of my old collections of Russian data of displays and things i found a basic diagram of how 10 pin LCD display configuration. 

PIN1   - VSS
PIN2   - VDD
PIN3   - CONTRAST
PIN4   - RS
PIN5   - R/W
PIN6   - ENABLE
PIN7   - DB4
PIN8   - DB5
PIN9   - DB6
PIN10 - DB7

I tried these configurations and wired up to the arduino with the LCD sketch and it worked on the first try. Adjusting the contrast and it was perfect. I hope this will help to those who looking for a solution.





Post a Comment

Popular Posts